(Newswire.net — July 1, 2019) — What are the new pool startup chemicals that you can use for a previously drained pool that has now been filled with clean water? Giving your pool the best chemical care it deserves will help you safeguard poor water conditions that may be time-consuming and expensive to rectify. The kind of pool chemicals you require will depend on the water balance from your water source. Some tap water makes good pool water, while other water sources need some adjustments so that their water balance will work well with chlorine without fading or staining your shiny and soft pool surfaces.
New Pool Startup Chemicals
Some new pool startup chemicals to have in your arsenal right after you’ve built your pool includes free chlorine, alkalinity, calcium hardness, and cyanuric acid.
How to Refill Your Pool with Fresh Water
You have several options, from filling from a truck to visiting your nearby fire hydrant to get fresh water for your pool. However, most homeowners prefer to use garden hose filling method when refilling pool water. If you have obtained your water from a well, then you need to filter it first before you refill your pool. You also need to test your freshly filled water using test strips or pool testing kits to ascertain its water balance levels.
New Pool Startup Chemicals Targets
When you are starting your pool, you want to make sure that each parameter is carefully tested to establish your starting chemistry or baseline, and later add some chemicals to lower or raise levels so that they are within the specified range:
- Free Chlorine: 1.0-3.0ppm
- Total Alkalinity: 80-120ppm
- Calcium Hardness: 180-220ppm
- Cyanuric acid: 30-50 ppm
- P.H.: 7.2-7.6
After doing your first water test, write the results down on a piece of paper so that you can get to them later when adding chemicals.
Adding Chemicals to a Freshly Filled Pool
Calcium Hardness
For pools that are situated in hard water regions, the tap water there has a higher degree of hardness mainly 400-600 ppm. This is way above the normal range of 180-220 ppm. In such a case, you need to use a calcium hardness reducing chemicals to rectify the problem.
pH Adjustments
Chlorine will always work well when your water pH is too low, but when it goes below 7.0, the water turns out to be corrosive and acidic. Use a pH decreaser or pH increaser to maintain the required pH range.
Chlorine Adjustments
Finally, after adding all the chemicals needed to make your pool safe, you need to raise the chlorine levels of your pool. Chlorine destroys any pathogens and contaminants that may be in your pool.
New Pool Startup Chemicals Required for a Freshly Filled Pool
Here is a list of chemicals that you will need for your fresh pool in your home:
- Test strips or pool test kits to help you determine the initial water balance
- Chlorine tablets
- pH decreasers or pH Increasers
- Calcium or Alkalinity Increaser
- Cyanuric acid (stabilizers)
- Clarifiers and algaecide if required
- Granular Shock chlorine
- Scale and stain preventer
Final Thoughts
The new pool startup chemicals listed above must be used regularly to keep the pool and water in a safe condition — when you’re using the pool and when it’s covered. With regular treating and testing of water, your pool will remain in good shape and be clean throughout all seasons. This article has discussed must-have pool chemicals that homeowners wanted to know.