What this covers
|
The Palisades Fire began on January 7, 2025. By Cal Fire’s final count it burned about 23,448 acres and destroyed 6,837 structures. For the homes still standing below the burned slopes, a second question starts every November, which is what happens when it rains.
This article explains how rain behaves on a burn scar, what that water carries, and what the first few days look like if it reaches a ground floor.
What a Burned Slope Does to Rainfall
Unburned hillside vegetation does two jobs in a storm. Roots and leaf litter slow the water down. The soil underneath soaks a share of it up. A fire removes both. The U.S. Geological Survey, which studies post-fire debris flows, reports that burned ground can shed water faster than unburned ground, because the plant cover is gone and the surface can become less able to absorb rain.
The result is more water moving over the surface, and moving faster. That is the mechanism behind a mud flow after a burn, and it is the reason the first rainy seasons after a fire carry the most risk.
Why Hillside Streets Feel It First
Pacific Palisades has a coast and a canyon side. The hillside areas, such as Castellammare, Marquez Knolls and Palisades Highlands, tend to see more rain than blocks near the water. They also sit directly under, or beside, slopes that burned.
Water from a hillside does not stop at a property line. It follows the grade. Driveways, side yards and street gutters act as channels, and a garage door or a basement stairwell at the low end becomes the place the water collects.
| Where water collects | Why it collects there | What it reaches first |
| Garage and basement stairwells | Lowest point on the lot | Stored items, drywall, baseboards |
| Side yards between houses | Funnel runoff toward the street | Exterior walls and door thresholds |
| Ground-floor doorways | Gap at the threshold | Flooring, subfloor edge |
| Crawlspaces | Vents sit near grade | Floor framing and insulation |
What the Water Carries
Rainwater on a roof is clean. Runoff across a burn scar is not. It crosses ash, soil, burned debris and ground that held fire retardant or household materials. The Institute of Inspection, Cleaning and Restoration Certification (IICRC) sorts water losses into categories by contamination. Surface runoff that has crossed open ground is normally treated as Category 3, the most contaminated category.
That affects every decision that follows. Category 3 water is handled with protective equipment, and porous materials such as carpet padding and drywall that sat in it are usually removed instead of dried.
Mud, Silt and What They Leave Behind
Even when the water drains, the fine silt it carried stays. Silt coats floors and wall bases and holds moisture against the surface. It also dries into a crust that is hard to see until you disturb it.
- Standing water has to be removed first. Drying equipment dries air and surfaces. It does not pump water out of a room.
- Silt and mud come out before any drying begins, or the equipment dries a layer of wet dirt.
- Anything that stayed wet for more than a day or two needs a moisture reading, not a visual check.
Silt from a burn area can also contain ash, and ash is alkaline, so it can irritate skin and eyes. Gloves, eye protection and a mask rated for fine particles are sensible for anyone cleaning it up. Wet silt is also heavy, which makes cleanup slower than it looks and clogs a wet vacuum quickly.
The First 48 Hours
The U.S. Environmental Protection Agency advises drying water-damaged areas and items within 24 to 48 hours to limit mold growth. That window is short, and burn scar storms often arrive when many neighbors need the same help at once.
Hours matter more than days here. A ground floor that is pumped out the same evening, opened up the next morning and running drying equipment by noon is in a different position from one where the first call is made on day three. Mold needs moisture, something organic to grow on and time. A wet house supplies the first two, so the third is the only one anyone controls.
A clean ground floor usually needs three jobs done in order. Water and debris come out. Wet materials are sorted into dry-in-place and remove. Then air movers push air across the wet surfaces while a dehumidifier pulls the moisture out of the room air. Without the dehumidifier, the water simply moves from the floor into the air and then into the next wall.
| Job | Who or what does it | What it does |
| Move water off the floor | Extraction by a contractor or the homeowner | Removes standing water and slurry |
| Move air across wet surfaces | Air mover | Speeds evaporation from floors and wall bases |
| Remove moisture from the air | Dehumidifier | Keeps the room from re-wetting itself |
| Clean the air | HEPA air scrubber | Filters fine ash and silt dust that rises while drying |
Reading the Forecast Differently
The National Weather Service forecast office for Los Angeles issues flood and flash flood warnings, and it watches burn areas more closely than unburned ground. The reason is intensity. U.S. Geological Survey research on post-fire debris flows finds that short bursts of heavy rain, not season totals, are what most often set a flow off.
A storm that spreads its water over a full day may do very little. The same amount of rain in under an hour can send mud downhill. The useful number in a forecast is therefore not the daily total. It is how hard the rain falls over a short period.
Preparing a Ground Floor Before the Rain
Preparation costs little and saves the most time. Most of it is about knowing where things are before the water arrives.
- Find the main water shutoff and the electrical panel, and make sure everyone in the house can reach both
- Move valuables, papers and stored boxes off the floor of a garage or lower level
- Clear gutters, downspouts and the drain at the bottom of any stairwell
- Photograph each ground-floor room so there is a record of its condition
- Save the phone number of a restoration contractor, and the access details a driver would need, such as a gate code
| Stage | What matters | Why |
| Before the storm | Clear drains, lift items off floors | Water leaves faster and less is touched |
| During the storm | Stay out of lower levels, keep power off wet areas | Moving water and live circuits are the main risks |
| After the water drains | Photograph, then call | The 24 to 48 hour window has started |
Records That Help Later
A timeline helps every person who works on the loss. Write down when the water arrived, how high it rose and when it was removed. Keep receipts for anything bought or rented. Photograph the wet areas before anything is moved.
Insurance treatment of rain, runoff and mud differs by policy, and many standard homeowner policies treat flood damage separately from other water damage. The wording is worth reading before a storm, not after one.
Where Rental Equipment Fits and Where It Does Not
Equipment rental suits a small, clean-water loss that a homeowner or a contractor is managing. It does not suit a Category 3 loss that a homeowner would handle alone. If runoff carried mud, debris or anything that could be sewage into the house, a licensed restoration contractor should lead the work. A contractor can bring their own equipment, or rent drying units for a job and keep the labor.
Los Angeles County covers more than 4,000 square miles, and a burn scar neighborhood is not close to every rental yard. Delivery time matters, because the 24 to 48 hour window starts when the water arrives and not when the equipment does. Gated communities add a step, since a driver needs a gate code before the equipment can reach the door.
What to Tell Whoever You Call
A clear description cuts the time to the right equipment. Say where the water came from. Say how long it stood. Say which rooms and which floor materials are wet. Say whether the lot has a gate or a steep driveway.
- The source of the water, such as rain runoff, a broken pipe or a roof leak
- Hours since the water arrived
- Square footage and floor type, such as hardwood, tile or carpet
- Access details for a delivery truck
Where to Look for Equipment Locally
Rental fleets such as Los Angeles Restoration Rentals list same-day drying equipment delivery in Pacific Palisades across The Village, the Alphabet Streets, Castellammare and Palisades Highlands, and they rent equipment only. A neighboring page covers air movers delivered to neighboring Santa Monica, and the service area appears on the Google Business Profile.
Burn scar water is a recurring local problem, so the winter pattern matters more than any one storm. A homeowner who knows how water moves downhill, what it carries and which jobs come first loses less time on the day it arrives.